Introduction
Copper rod and copper bar are the starting point for countless products — from electrical conductors and busbars to machined fittings and decorative architecture. Although the two terms are often used interchangeably, sourcing teams need to specify grade, diameter and temper precisely, or the material will fail on the machine or in service. This guide covers what to check before you buy.




Copper Rod vs Copper Bar
In practice, a copper rod usually refers to a solid round section, while a copper bar can be round, square, rectangular or hexagonal. Both are produced from the same families of copper, and the same grade rules apply. What matters is the cross-section, the diameter or width, and the tolerance your application can accept.
Grade Selection: C11000, C10100 and Alloys
| Grade | Type | Conductivity (IACS) | Typical Use |
|---|---|---|---|
| C11000 | ETP copper | ≈100% | Busbar, electrical, general machining |
| C10100 | Oxygen-free | ≈101% | Vacuum, electronics, brazing |
| C18200 | Chromium copper | ≈80% | Electrodes, resistance welding |
| C70600 | Cupronickel | ≈9% | Marine, seawater service |
For most electrical and general industrial work, C11000 is the correct and most economical choice. Move to C10100 only when ultra-low oxygen is required; move to an alloy such as C18200 or C70600 when you need strength, wear resistance or seawater corrosion resistance.
Diameter and Tolerance
Copper rod is supplied in diameters from a few millimetres up to 300 mm. Two tolerances decide whether the rod runs cleanly through your machine: the diameter tolerance and the straightness. For automatic lathes and high-speed drawing lines, specify drawn-and-straightened rod with tight ovality control; for general fabrication, mill tolerance is usually sufficient.
Tempers Explained
- Soft (annealed, O): maximum ductility — best for bending and forming.
- Half hard (H02): balanced strength and ductility for general machining.
- Hard (H04): highest strength and wear resistance for springs and contacts.

Typical Applications
- Electrical conductors, terminals and connectors
- Busbars and grounding systems
- Precision machined parts, fittings and fasteners
- Decorative and architectural metalwork
- Marine and desalination components (cupronickel)
Quality Checklist Before You Buy
- Confirm grade and conductivity (IACS) with a mill test certificate.
- Verify diameter, length and straightness against your drawing.
- Check surface for cracks, seams and oxidation.
- Confirm temper matches your forming or machining process.
Why Buy Copper Rod from SYLAITH
WUXI SYLAITH SPECIAL STEEL CO., LIMITED (brand SYLAITH) supplies pure copper rod and bar in C11000, C10100, C10200 and C12000, plus brass, bronze and cupronickel alloys, cut to your required diameter and length. Each lot ships with inspection documentation, stable quality and reliable export service, so your production line keeps running without surprises.
Request a Quote
Send your grade, diameter, temper and quantity to sales2@slssteel.com and our team will reply within one working day with specification, MOQ, lead time and price basis.